NoCal TM is a line powered RF point level device that requires no calibration! Imagine, the power of RF application diversity with no calibration required! With one powerful, simple device! As with all Drexelbrook RF devices, there are no moving parts that can break or wear out.  NoCal LCS with our Perm-A-Seal injection molded sensor is ideal for most any point level application.

Setup is as easy as:

Applicable Materials:

Features include:

The LCS product line consists of line powered switches that are designed for local control. Output is through DPDT relay contacts. Cote Shield™ circuitry allows the switch to ignore material buildup on the sensing element. Typical applications include high/low level indication, pump start/stop control, plugged chute detection, and interface indication. Agency approvals include FM, CSA.

The LCT products are two wire devices that are designed for centralized control. The out put from the LCT is a 4 to 20 mA signal that can be feed to a Receiver package, PLC, or DCS. Cote Shield™ circuitry allows the switch to ignore material buildup on the sensing element. Typical applications include overfill/spill prevention and general high level indication. Agency approvals include FM, CSA, KEMA, PTB, SAA, and TUV.

Z-tron™ - These are line powered switches intended for general purpose applications. Output is through DPDT relay contacts. Cote Shield™ circuitry allows the switch to ignore material buildup on the sensing element. Typical applications include high/low level indication and pump start/stop control. These budget priced switches are for use where approvals are not required.

Our line powered multiple point switch which offers up to four control points on a signal sensing element. Output is through DPDT relay contacts. Cote Shield™ circuitry allows the switch to ignore material buildup on the sensing element. Typical applications include sumps where pump start/stop and high/low indication are required and batch processes. Approvals for the MultiPoint II are pending.

These switches include a special verify circuit which allows a manual or automatic confidence check of the entire control loop. Verify circuitry calibration, wiring, sensor, and electronic unit to insure that the switch will function when needed. Cote Shield™ circuitry allows the switch to ignore material buildup on the sensing element. Use the Maximum Security system with Verify for overfill and spill prevention.

The Perm-A-Seal sensor has an ejection molded gland seal that completely eliminates the possibility of leaks. Cote Shield™ circuitry allows the switch to ignore material buildup on the sensing element. Use it for preventing fugitive emissions or high level indication.

© Pneumatic Control, Inc. 1999/2000