Featurs and Options:

• Controlled by Motorola microcontroller
• Pushbutton setpoint signal calibration (zero and span)
• Pushbutton process signal calibration (zero and span)
• Selectable action on setpoint or process signal failure. Hold None Go to position
• Invalid feed back potentiometer signal Go full clockwise Go full counter clockwise Hold or none
• PID controller, fully programmable
• Contained within the actuator
• High resolution
• Maintains cycle count (accumulated cycle times)
• Monitors highest/lowest process values
• Programmable direct or reverse acting
• Programmable deadband
• Programmable operating parameters
• Electronic travel limits 0 PID autotune
• Security code 0 Unit address selection
• Pushbutton restoration of factory defaults
• Selectable baud rates 1200 bps to 38K bps 

I/O Options:

• Setpoint inputs (standard) 
  4-20 mA 
  1000 ohm potentiometer
  Local
  1 digital RS485 input
• Setpoint inputs (optional)
  1-5 mA
   10-50 mA
  135 ohm potentiometer
  0-5 VDC
  0-10 VDC
• Process inputs available:
  4-20 mA analog
  1 or 2 1 00 ohm platinum RTD
  Thermocouple Type J, K, T, E

© Pneumatic Control, Inc. 1999/2000